1. Prevent the conveyor belt from starting.
2. If the conveyor belt runs off, measures should be taken to correct it.
3. Conveyor belts of different types and specifications should not be used together, and the joints are preferably glued.
4. The type, structure, specification and number of layers of ordinary conveyor belts and special conveyor belts should be reasonably selected according to the conditions of use.
5. The running speed of the conveyor belt is generally not more than 2.5m/s. The block size is large, and the material with large wear and the fixed discharge device should use low speed as much as possible.
6. The relationship between the diameter of the drive roller of the roller conveyor and the layer of the conveyor belt, the matching of the drive roller, the reversing roller and the groove angle of the roller should be based on the conveyor.Design regulations, reasonable selection.
7. The feeding direction should be in the running direction of the conveyor belt. In order to reduce the impact on the conveyor belt when the material falls, the chute should be adopted to reduce the distance of the material drop; the receiving section of the conveyor belt should be.Shorten the roller spacing and use the buffer roller as the leakage conveyor belt to adopt the soft and moderate material blocking plate, so as to avoid the material plate being too hard and scraping the belt surface of the conveyor belt.
8. When the conveyor is in use, if there is no roller, it should be added and repaired in time; the roller is covered by the material, causing the rotation to be ineffective, preventing the leakage from getting stuck between the roller and the tape.Pay attention to the lubrication of the active part of the conveyor belt, but not the oil conveyor belt.
9. Avoid the conveyor belt being blocked by the frame, pillar or block material to prevent breakage and tearing. When the industrial cupcake machine conveyor belt is partially damaged, apply artificial cotton in time to avoid expansion.
Leave a Message :::